Back: Introducing Makefiles
Forward: Makefile syntax
 
FastBack: Introducing Makefiles
Up: Introducing Makefiles
FastForward: A Minimal GNU Autotools Project
Top: Autoconf, Automake, and Libtool
Contents: Table of Contents
Index: Index
About: About this document

4.1 Targets and dependencies

The make program attempts to bring a target up to date by bring all of the target's dependencies up to date. These dependencies may have further dependencies. Thus, a potentially complex dependency graph forms when processing a typical `Makefile'. From a simple `Makefile' that looks like this:

 
all: foo

foo: foo.o bar.o baz.o

.c.o:
        $(CC) $(CFLAGS) -c $< -o $@

.l.c:
        $(LEX) $< && mv lex.yy.c $@

We can draw a dependency graph that looks like this:

 
               all
                |
               foo
                |
        .-------+-------.
       /        |        \
    foo.o     bar.o     baz.o
      |         |         |
    foo.c     bar.c     baz.c
                          |
                        baz.l

Unless the `Makefile' contains a directive to make, all targets are assumed to be filename and rules must be written to create these files or somehow bring them up to date.

When leaf nodes are found in the dependency graph, the `Makefile' must include a set of shell commands to bring the dependent up to date with the dependency. Much to the chagrin of many make users, up to date means the dependent has a more recent timestamp than the target. Moreover, each of these shell commands are run in their own sub-shell and, unless the `Makefile' instructs make otherwise, each command must exit with an exit code of 0 to indicate success.

Target rules can be written which are executed unconditionally. This is achieved by specifying that the target has no dependents. A simple rule which should be familiar to most users is:

 
clean:
	-rm *.o core


This document was generated by Joost van Baal on August, 23 2005 using texi2html