Back: Introducing GNU Automake
Forward: Introduction to Primaries
 
FastBack: Introducing GNU Automake
Up: Introducing GNU Automake
FastForward: Bootstrapping
Top: Autoconf, Automake, and Libtool
Contents: Table of Contents
Index: Index
About: About this document

7.1 General Automake principles

Automake at its simplest turns a file called `Makefile.am' into a GNU-compliant `Makefile.in' for use with `configure'. Each `Makefile.am' is written according to make syntax; Automake recognizes special macro and target names and generates code based on these.

There are a few Automake rules which differ slightly from make rules:

  • Ordinary make comments are passed through to the output, but comments beginning with `##' are Automake comments and are not passed through.

  • Automake supports include directives. These directives are not passed through to the `Makefile.in', but instead are processed by automake -- files included this way are treated as if they were textually included in `Makefile.am' at that point. This can be used to add boilerplate to each `Makefile.am' in a project via a centrally-maintained file. The filename to include can start with `$(top_srcdir)' to indicate that it should be found relative to the top-most directory of the project; if it is a relative path or if it starts with `$(srcdir)' then it is relative to the current directory. For example, here is how you would reference boilerplate code from the file `config/Make-rules' (where `config' is a top-level directory in the project):

     
    include $(top_srcdir)/config/Make-rules
    

  • Automake supports conditionals which are not passed directly through to `Makefile.in'. This feature is discussed in 19. Advanced GNU Automake Usage.

  • Automake supports macro assignment using `+='; these assignments are translated by Automake into ordinary `=' assignments in `Makefile.in'.

All macros and targets, including those which Automake does not recognize, are passed through to the generated `Makefile.in' -- this is a powerful extension mechanism. Sometimes Automake will define macros or targets internally. If these are also defined in `Makefile.am' then the definition in `Makefile.am' takes precedence. This feature provides an easy way to tailor specific parts of the output in small ways.

Note, however, that it is a mistake to override parts of the generated code that aren't documented (and thus `exported' by Automake). Overrides like this stand a good chance of not working with future Automake releases.

Automake also scans `configure.in'. Sometimes it uses the information it discovers to generate extra code, and sometimes to provide extra error checking. Automake also turns every AC_SUBST into a `Makefile' variable. This is convenient in more ways than one: not only does it mean that you can refer to these macros in `Makefile.am' without extra work, but, since Automake scans `configure.in' before it reads any `Makefile.am', it also means that special variables and overrides Automake recognizes can be defined once in `configure.in'.


This document was generated by Joost van Baal on August, 23 2005 using texi2html